Lines interrupted by drawings
#14
Thank you, RobGea! As always with the VMS, there are cases that are particularly difficult to classify. The word at the top is an ordinary image-break, but for the detail that the word on the right appears isolated, with no other words above or below.
The one at the bottom is rendered as a single word in ZL, but I agree that there could be a split.

In general, the page is particularly rich in text/image overlaps. Thank you for pointing it out!


Attached Files Thumbnail(s)
   
[+] 1 user says Thank You to MarcoP for this post
Reply


Messages In This Thread
Lines interrupted by drawings - by MarcoP - 25-09-2019, 10:10 AM
RE: Lines interrupted by drawings - by Davidsch - 25-09-2019, 04:12 PM
RE: Lines interrupted by drawings - by MarcoP - 25-09-2019, 07:36 PM
RE: Lines interrupted by drawings - by Koen G - 25-09-2019, 08:06 PM
RE: Lines interrupted by drawings - by bi3mw - 25-09-2019, 09:24 PM
RE: Lines interrupted by drawings - by -JKP- - 26-09-2019, 01:03 AM
RE: Lines interrupted by drawings - by Davidsch - 26-09-2019, 04:03 PM
RE: Lines interrupted by drawings - by MarcoP - 28-09-2019, 08:11 AM
RE: Lines interrupted by drawings - by RobGea - 30-09-2019, 02:13 PM
RE: Lines interrupted by drawings - by MarcoP - 30-09-2019, 05:49 PM
RE: Lines interrupted by drawings - by bi3mw - 30-09-2019, 05:54 PM
RE: Lines interrupted by drawings - by -JKP- - 01-10-2019, 12:09 AM
RE: Lines interrupted by drawings - by MarcoP - 05-10-2019, 04:37 PM
RE: Lines interrupted by drawings - by MarcoP - 06-10-2019, 12:27 PM
RE: Lines interrupted by drawings - by MarcoP - 24-10-2019, 05:22 PM
RE: Lines interrupted by drawings - by MarcoP - 26-10-2019, 07:06 AM
RE: Lines interrupted by drawings - by Davidsch - 29-10-2019, 01:38 PM
RE: Lines interrupted by drawings - by asteckley - 29-04-2024, 03:11 PM
RE: Lines interrupted by drawings - by dfs346 - 02-05-2024, 08:59 AM
RE: Lines interrupted by drawings - by asteckley - 03-05-2024, 06:36 AM
RE: Lines interrupted by drawings - by dfs346 - 13-07-2024, 10:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)